My personal recommendation is to buy the Synology DS218+. The performance is crap.Īs far as what difference it makes for audio, it only matters that the NAS can fetch and send data fast enough for the endpoint not to stutter during playback or have to wait a really long time finding the next song. Just avoid any NAS using an ARM processor. Generally speaking, either would be fine for a 2 bay NAS. Some sellers advertise this number instead, because bigger is better in the minds of customers. You'll also note that each are capable of burst speeds over 2.4Ghz. If transcoding 4k video is important to you, the quad-core processor can't do it. Quad-core should be faster than dual-core, yes? Generally, yes, but the dual-core processor is newer, has more robust graphics processing, and the newer gen architectural improvements might close the gap in performance. The Synology uses Intel Celeron J3355 Dual-core 2.0 GHz. The QNAP uses a Intel® Celeron® J1900 quad-core 2.0 GHz processor. They should perform the same then, ya? NO. The Synology DS218+ also has a 2.0Ghz processor. It is advertised as having a 2.0Ghz processor. For example, the QNAP TS-251+ is a pretty good home NAS. You really need to know the specific processor that's in there too determine how fast the processor is. Hope it's a little useful!)Ĭlick to expand.Processor speed is misleading. (I don't actually have any experience with this yet, but I've been researching it for a few weeks and have been considering moving my Roon server to a NAS. I think they're exaggerating about needing an i3/i5 instead of a celeron, since Synology says their celeron NASs can do 4k transcoding.I wrote all that and then remembered that Roon had a page on this on their site.Tl dr get an SSD and figure out how much data resilience you need. I guess you could also just put two large SSDs in and RAID them, but that sounds excessive. Roon is sort of unbearably slow without the SSD, so you're looking at either a 2 bay NAS with 1 SSD & 1 data HDD or a 4 bay with the SSD & a pair of RAID1 HDDs. You can usually just buy RAM separately and slot it in, and most entry-level Synology boxes I've seen support at least 6GB. You'll probably want 4+ GB RAM and an SSD for the Roon database.As long as the hard drive & network connection are fast enough, it's unlikely to be the bottleneck.ī) Run the Roon server on the NAS itself: It probably doesn't matter what NAS you use with this route. I've mostly been looking at Synology and Terramaster NAS units so far.Ĭlick to expand.So if you're considering Roon with a NAS, you have a couple options.Ī) Run the Roon server on another computer you have, using the NAS only for storage: Maybe someone can explain this further.īeing a cheap bastard, I guess I'm trying to find out if I could go with one of the cheaper NAS units with "worse" specs, or if I need to spend more to hit some level of minimal requirements that would work significantly better as a music server. "DS218play does not support PLEX" - ok, I googled what PLEX is, but I'm not sure if this is of any benefit to me. ( not to be confused with the computers OS) Is this just marketing BS, or is there anything I should focus on (or avoid) or is it completely irrelevant for audio? Most of the NASs I've looked at mention they're using some specific operating system. What relevance does this have on audio, or is it simply related to how fast tracks can be accessed or multitasking capabilities? What is the difference between DDR3 and DDR3L and does it matter here? Also does the extra GB do much for me? I also googled some of the terms but didn't find anything specific to audio.ġ GB DDR3 vs. I do have some software engineering experience so I know the fundamentals as they apply to general computing, but not as they may relate to audio. I may consider ROON at some time in the future also. In the future I'll probably either build a NUC or find some branded easy solution box to output into a Yggdrasil. But this has become a hassle and I want to consolidate content into a 2 or 4 bay NAS with the primary disc being an SSD. I currently have several older hard drives that I periodically hook via USB to a Mac Mini or a Raspberry Pi. I'm looking to buy a diskless NAS in the future but am confused by all the specs and how they might be relevant when using the NAS to store FLAC and WAV files and use as a music server.
0 Comments
Leave a Reply. |